bonsai general - 0 views
Yaupon holly has been on my mind this week. I’m doing a show in a night at a club meeting of the American Bonsai Association, Sacramento, and I’ve been collecting notes about your care.
Since I started working on Yaupon holly – formally known as Ilex vomitoria – I’ve come to really appreciate the variety. It is well suited for bonsai because it has small leaves, grows fast and quickly branches -. If you know the trick
I started working in the Yaupon holly makes under 12 years. This is what it looked like before I made the first cut.
Yaupon holly, 2004
And this is after making the first cut -. A large
After reducing the apex
The tree was not much to do at this point. As the tree grew in poor soil, repotted in Boon mixture was allowed to grow for several years, and in 2007, was full again.
Yaupon holly, 2007
Serious work began that year when Michael Hagedorn came to visit. Michael radically cut the tree back leaving thin shoots that could be used to create new primary branch.
I let the tree grow over the next two years and then further reduced branches, keeping only the branches that could used in the final design.
Two years later – after trimming 2009
As you can see, there is no significant progress here. This was the idea that there was a better way to approach development Yaupon holly branch.
Boon Manakitivipart and I had found that reducing dramatically branches caused a lot of new shoots that emerge. What we need at this stage of development, was a smaller number of elongated enough to start the thickening of the branches buds.
The following year, Boon suggested thinning tree instead of shortening all branches. I gave it a try. Here is the tree before thinning.
Yaupon holly – March 2010
And here is the tree after thinning.
Yaupon holly after thinning
Actually the tree does not look like much at this point either. Leaving the branches and gave the tree a shaggy appearance. These long branches continued, however, to lengthen which increased its size that emerged from the trunk. This, it turns out that was the trick :. A fine new growth rather than reduce it
In December, the branches had swelled considerably -. To the extent that I was able to reduce them, as shown below to improve Taper branch and branch
Yaupon holly – December 2010
Now that was a repeatable process – let the branches are extended for one or two years before reducing them – the tree developed rapidly. Here is the tree two years later.
whole again – June 2012
And this is after trimming.
After trimming – July 2012
This was the first time I had a sense of what the final design will look like. Just two years later, I was able to show the tree in the annual exhibition Bay Island Bonsai -. 10 years after making the first cut
As shown in the exhibition 2014 Bay Island Bonsai – 11 “
Now that the tree is fairly well developed, maintenance is simple. I leave the tree alone during the growing season, thin and shorten the branches once or twice a year.
Now my biggest concern is the time cut for the best foliage exhibits last summer the tree was full but needed to thin the foliage at least once. – and possibly twice -. Before an exhibition scheduled for the following winter
I knew I could asphaltic 1-2 times before 2016 exhibition bay island Bonsai, depending on the speed with which the tree grew summer . I thinned the tree in July and reduced new outbreaks of 2-3 leaves.
After thinning and reduction
After smaller cut in autumn, the tree was ready to go last winter.
Yaupon holly as set forth in 2016 the exhibition Bay Island Bonsai
As I head to Sacramento for the show tonight, I to be considering branching want to leave long and which to fade -. the main trick for the development of Yaupon bonsai holly
the post develop Yaupon bonsai holly – a story of when not cut appeared first time on Bonsai Tonight
This article was originally published on bonsaitonight.com